Kenmore Elite 27'' Electric Combination Wall Oven Guide d'installation télécharger pdf (Page 4)

If oven is used in a new branch circuit installation

(1996 NEC), mobile home, recreallonal vehicle, or

where local codes DO NOT permit grounding through

the neutral (white) wire, the appliance frame MUST

NOT be connected to the neutral wire of the 4-wire

electrical system. (see figure 3):

1. Disconnect the power supply.

2. Separate the green (or bare copper) and white appliance

cable wires.

3. In the junction box:

Connect appliance and power supply cable ,,vires as

shown in Figure 3.

Cable from Power Supply

Ground Wie--_ _-_

"X,[_.L_L>.I _ --'_-"---_ ,-White Wire

Wires--_' ,,'_ _

Ground Wire ' _/, Wire

(Bare or Oreen---_ _ i_

Wire) _ _ L_:_White Wire

/ L]

Junction Box i _]_,' U"_.L.-ListedConduit

_r4_ Connector (or CSA listed)

Cable from appliance

Figure 3

4-WIRE GROUNDED JUNCTION BOX

Model and Serial Number Location

The serial plate is located along the interior side trim of the

oven and visible when the door is opened.

When ordering parts for or making inquires about your oven,

always be sure to include the model and serial numbers and a

lot number or letter from the serial plate on your oven.

4. Cabinet Installation

Do not llft the oven by the door handle.

Heavy Weight Hazard

* Use 2 or more people to move and install wall oven.

* Failure to follow this instructlon can resuff in injury or

damage to the unff.

Unpack the wall Remove the bottom trim and the

oven.

center trim taped on the oven side panel.

O Remove the lower oven door to reduce the weight the

appliance and to facilitate its handling and its installation.

To Remove Oven Door.

1. Open oven door completely (horizontal with floor- See

Figure 4A).

2. Pull the door hinge locks on both left and right door hinges

down from the oven frame completely towards the oven

door (See Figure 4B). A tool such as a small fiat-blade

screwdriver may be required.

3. Firmly grasp both sides of oven door along the door sides

(Do not use the oven door handle- See Figure 4C).

4. Close the door to the broil stop position (the oven door ,,viii

stop into this position iust before fully closing).

5. With the oven door in the broil stop position, lift the oven

door hinge arms over the roller pins located on each side of

the oven frame (See Figure 4D).

6. Proceed in reverse to replace the oven door. Make sure the

hinge supports are fully engaged before unlocking the hinge

levers.

NOTE: The oven door is very heavy. Be sure to have a firm grip

before lifting the oven door off the hinges. Use caution once

the door is removed. Do not lay door on its handle. This could

cause dents or scratches.

Door Hinge

locations

wffh oven

door fully

open

Figure 4B

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Kenmore Elite 27'' Electric Combination Wall Oven Guide d'installation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Kenmore Elite 27'' Electric Combination Wall Oven