Kenmore Elite 27'' Electric Combination Wall Oven Guide d'installation télécharger pdf (Page 2)

ImportantNotesto the Installer

1. Read aii instructions contained in these installation

instructions before installing the combination oven.

2. Remove all packing material from the oven compartments

before connecting the electrical supply to the wail oven.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumen

5. Oven door may be removed to facilitate installation.

6. THIS COMBINATION OVEN IS NOT APPROVED

FOR STACKABLE OR SIDE=BY=SIDE INSTALLATION.

Important Note to the Consumer

Keep these instructions with your Owner's Guide for future

reference. Do not discard oven removal tools found in the

literature bag.

IMPORTANT SAFETY

INSTRUCTIONS

* Be sure your combination oven is installed and

grounded properly by a quallfied installer or service

technician.

* This wall oven must be elecfrlcaily grounded in

accordance with local codes or, in their absence,

with the Natlonal Elecfrlcal Code ANSi/NFPA No.70=

latest edition in United Sates, or wlth CSA Standard

C22.1, Canadian Electrlcal Code, Part 1, in Canada.

Stepping, leaning or sitting on the door

of thls wall oven can result in serious injuries and can

also cause damage to the wall oven.

* Never use your wall oven for warming or heating

the room. Prolonged use of the wail oven without

adequate ventilation can be dangerous.

The electrlcal power to the oven must be

shut off while llne connections are being made. Failure

to do so could result in serious injury or death.

1. Carpentry

Refer to figure 1 for the dimensions applicable to your

appliance, and the space necessary to receive the

combination oven. The oven support surface may be solid

plywood or similar material, however the surface must be

leveled from side to side and from front to rear.

2. Electrical Requirements

This appliance must be supplied with the proper voltage and

frequency, and connected to an individual, properly grounded

branch circuit, protected by a circuit breaker or fuse. To

know the circuit breaker or fuse required by your model, see

the serial plate to find the wattage consumption and refer to

table A to get the circuit breaker or fuse amperage.

Appliance I I

Protection App !ance Pr0tect_0n

Rating Watt s Circuit Circuit

24OV Recommended Recommended

Lessthan 4800W 20A 20A

4800W - 7200W 30A 30A

7200W - 9600W 40A 40A

9600W and + 50A 50A

Rating Watts

208V

Lessthan 4100W

4100W - 6200W

6200W - 8300W

8300Wand+

TabJe A

Observe all governing codes and local ordinances

I A 3wire or 4wire single phase 120/240 or 120/208 Volt,

60 Hz AC only electrical supply is required on a separate

circuit fused on both sides of the line (red and black wires).

A time-delay fuse or circuit breaker is recommended. DO

NOT fuse neutral (white wire).

NOTE: Wire sizes and connections must conform with the

fuse size and rating of the appliance in accordance with the

American National Electrical Code ANSI/NFPA No. 70-{atest

edition, or with Canadian CSA Standard C22.1, Canadian

Electrical Code, Part 1, and local codes and ordinances.

An extension cord should not be used

wlfh this appliance. Such use may result in a fire,

electrlcal shock, or other personal injury. If you need a

longer power cord you can purchase a 10' (3 m) power cord

kit by calling the Service Center.

These appliances should be connected to the fused

disconnect (or circuit breaker) box through flexible

armored or nonmetallic sheathed cable. The flexible

armored cable extending from the appliance should be

connected directly to the junction box. The junction box

should be located as shown in Figure 1 and with as much

slack as possible remaining in the cable between the box

and the appliance, so it can be moved if servicing is ever

necessary.

3. A suitable strain relief must be provided to attach the

flexible armored cable to the junction box.

In cold weather shipping and storage

conditions, make sure that oven is in final location at least

three (3) hours before switching on power. Switching on

power while oven is still cold may damage the oven contro{s.

1 2 3 4 5 6 7 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

Kenmore Elite 27'' Electric Combination Wall Oven Guide d'installation Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Kenmore Elite 27'' Electric Combination Wall Oven