Kenmore 22352 Manuel du propriétaire télécharger pdf (Page 12)

TROUBLESHOOTING

If you experience Possible Causes Solution

Vibration or Off-Balance

Check the following for

proper installation or

see “Using Your Washer”

section.

Feet may not be in contact with the

oor and locked.

Front and rear feet must be in rm contact with oor, and

washer must be level to operate properly.

Washer may not be level. Check oor for exing or sagging. If ooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See “Level the Washer” in Installation Instructions.

Load could be unbalanced. Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Wash smaller loads to reduce imbalance.

Do not tightly pack. Avoid washing single items.

Use Bulky/Bedding cycle for oversized, non-absorbent items such

as comforters or poly-lled jackets.

See “Cycle Guide” and “Using Your Washer” in this Use and

Care Guide.

Noises

Clicking or metallic noises Objects caught in washer drain

system.

Empty pockets before washing. Loose items such as coins could

fall between basket and tub or may block pump. It may be

necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the basket.

Gurgling or humming Washer may be draining water. It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as nal amounts of water

are removed during the Drain/Spin cycles.

Humming Load sensing may be occurring. You may hear the hum of the sensing spins after you have started

the washer. This is normal.

Whirring Basket deceleration may be occurring. You may hear the whirring sound of the basket decelerating. This

is normal.

Water Leaks

Check the following for

proper installation:

Washer not level. Water may splash o basket if washer is not level.

Fill hoses not attached tightly. Tighten ll-hose connection.

Fill hose washers. Make sure all four ll hose at washers are properly seated.

Drain hose connection. Pull drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Check household plumbing for leaks

or clogged sink or drain.

Water can back up out of a clogged sink or drainpipe. Check

all household plumbing for leaks (laundry tubs, drain pipe, water

pipes, and faucets).

Washer not loaded as recommended. Unbalanced loading can cause basket to be out of alignment

and cause water to splash o tub. See “Using Your Washer”

for loading instructions.

Washer Not Performing As Expected

Not enough water

in washer

Load not completely covered in water. This is normal operation for a high eciency washer. If the Water

Level knob is set to Auto setting, the load will not be completely

under water. The washer senses load sizes and adds correct

amount of water for optimal cleaning.

Use Bulky/Bedding or Jeans/Towels cycle for higher water ll,

or set Water Level knob to Deep Fill setting. See “What’s New

Under the Lid” and “Cycle Guide” to match your load with the

best cycle.

Run Clean Washer cycle to optimize the water level and wash

performance due to soil buildup in washer basket.

First try the solutions suggested here

for assistance and to possibly avoid a service call.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Kenmore 22352 Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Kenmore 22352