Kenmore 87050 Manuel du propriétaire télécharger pdf (Page 5)

To begin operating the air conditioner, follow these steps:

1. Set the temperature selector to the highest number (coldest or coolest setting).

2. Set the mode control to the High Cool setting.

3. Adjust the louvers for comfortable air flow (see Air Directional Louvers).

4. Once the room has cooled, adjust the temperature selector to the setting you find most comfortable. Refer to the

instructions below.

This is used to set the desired room temperature when the unit is being

operated in the “COOL MODE”.

To set the desired room temperature, rotate the selector switch to the desired

setting. After the set temperature is achieved, the thermostat will automatically

start and stop the compressor in order to maintain the desired set temperature.

Rotate the temperature selector clockwise for higher cool setting. Higher cool

settings will provide lower room temperature.

Rotate the temperature selector counter-clockwise for lower cool settings.

Lower cool settings will provide higher room temperature.

Temperature Selector

Cool Mode

The desired cool setting is selected by rotating the MODE knob to the

appropriate location.

“High Cool” has maximum cooling effect and airflow.

“Low Cool” has minimum cooling effect and airflow.

Fan Mode

Rotate the MODE knob to select your choice of fan speeds for air circulation

only.

Note: When selecting a fan speed, the compressor will not run.

Air directional louvers control air flow direction. Your air

conditioner has the 2-way directional system described below.

The louvers will allow you to direct the air Left or Right throughout the

room as needed. Rotate the Auger Wheel until the desired Left or Right

direction is obtained. There are a total of 2 possible air directional

orientations available with this system.

AUGER WHEEL

LOUVERS

Air Conditioner Features

Models with a key hole overflow drain hole can use drain kit 5304481680 to connect a 1/2 inch drain hose for safe

disposal of excess system water. This part can be ordered at www.SearsPartsDirect.com.

Please always wait 3 minutes when turning unit off then on again, and when changing from cool to fan and back to

cool. This prevents compressor from overheating & possible circuit breaker tripping.

Failure to follow these instructions may be harmful to your unit.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Kenmore 87050 Manuel du propriétaire Page 5